Barbell Side Lunge vs Landmine Squat

Barbell Side Lunge vs Landmine Squat Strength Standards

Use these tables to compare the estimated one-rep max required for the barbell side lunge and landmine squat to reach the same strength level at each listed bodyweight. The numbers are calculator targets, not a required gap between the two lifts.

Choose the men’s or women’s table, find the closest bodyweight row, and read across to Novice, Intermediate, Advanced, or Elite. Each entry shows Barbell Side Lunge / Landmine Squat, with pounds above kilograms. Use the calculator for your exact bodyweight and recent sets.

Men’s Barbell Side Lunge vs Landmine Squat Standards

How to read the table: Find the closest bodyweight, then use the labeled exercise row. Every strength-level entry shows one target with pounds first and kilograms beneath it.

Women’s Barbell Side Lunge vs Landmine Squat Standards

How to read the table: Find the closest bodyweight, then use the labeled exercise row. Every strength-level entry shows one target with pounds first and kilograms beneath it.

How Your Barbell Side Lunge vs Landmine Squat Result Is Calculated

Each set is converted to an estimated max before the calculator assigns exercise-specific strength levels and compares them.

1. Estimate a one-rep max from each set

A one-rep set uses the entered weight. For 2–12 reps, both formulas are calculated and the lower estimate is retained.

• Epley: weight × (1 + reps ÷ 30)
• Brzycki: weight × 36 ÷ (37 − reps)

Use recent Barbell Side Lunge and Landmine Squat sets with consistent technique and full intended range of motion. Difficult lower-rep sets generally make the estimated max less dependent on extrapolation.

2. Find the barbell side lunge strength level

For barbell side lunge, the individual exercise thresholds start from reference bodyweights of 190 lb for men and 150 lb for women. Exact-bodyweight targets use reference target × (user bodyweight ÷ reference bodyweight) to the two-thirds power.

The target rises more slowly than bodyweight so larger lifters are expected to lift more without requiring strength to increase pound for pound.

3. Find the landmine squat strength level

The standards use the sex-specific strength levels from the individual Landmine Squat tool. Targets begin at 190 lb for men and 150 lb for women, then adjust to exact bodyweight with reference target × (user bodyweight ÷ reference bodyweight) to the two-thirds power.

The target rises more slowly than bodyweight so heavier lifters are expected to squat more loaded free-end weight without requiring strength to increase pound for pound.

4. Compare the two results

Strength level decides the comparison first. Matching levels remain Balanced unless progress toward the next target differs by at least 10 points.

The result identifies the lower standards rating, not its cause. Technique, fatigue, training history, and set quality can all affect the comparison. Age range is recorded anonymously but does not change these standards.

Use the calculator above to view both estimated maxes, strength levels, next targets, and the resulting priority or Balanced verdict.

How Men’s Barbell Side Lunge and Landmine Squat Standards Differ

How to read this chart: Choose a strength level and follow its line across bodyweight. Values show the Landmine Squat standard minus the Barbell Side Lunge standard: zero means equal, above zero means the Landmine Squat standard is higher, and below zero means the Barbell Side Lunge standard is higher. Swipe horizontally on mobile. Use the standards table for exact lb/kg targets.

How Women’s Barbell Side Lunge and Landmine Squat Standards Differ

How to read this chart: Choose a strength level and follow its line across bodyweight. Values show the Landmine Squat standard minus the Barbell Side Lunge standard: zero means equal, above zero means the Landmine Squat standard is higher, and below zero means the Barbell Side Lunge standard is higher. Swipe horizontally on mobile. Use the standards table for exact lb/kg targets.

Barbell Side Lunge and Landmine Squat Exercises Used by This Calculator

For a useful comparison, perform a strict barbell side lunge and a strict landmine squat using the setup and load rules below. Use strict, repeatable Barbell Side Lunge and Landmine Squat tests that follow each exercise’s setup, range of motion, equipment, and load rules. Do not mix variations, assistance, partial range, momentum, or different load conventions.

Use the exercise-specific Barbell Side Lunge setup and load convention

Barbell is positioned on the upper back; high-bar or low-bar placement is allowed. Lifter begins standing upright with feet hip-width apart. Lifter steps laterally into a wide stance. Working foot remains flat and planted throughout the rep. Lifter descends by sitting into the working hip. Non-working leg remains extended with minimal knee bend. Working thigh reaches at least parallel, with hip crease at or below knee level. Each repetition counts only after returning to a fully upright standing position with hips and knees extended and feet returned under the body. Torso remains neutral with minimal forward collapse or rotation. Each rep is controlled with consistent depth, step width, and tempo. Reps are performed evenly on both sides; weaker side determines valid load and rep count. Raw lifting only; no equipped or assisted support is included. No shallow side steps without clear depth, forward or rotational lunge substitutions, excessive torso lean, momentum-assisted returns, assisted variations, machine-based lateral lunges, Smith machine variations, partial reps, uneven step widths, or equipped lifting are included. Load input represents total barbell weight only, not bodyweight. Standards reflect unilateral lower-body strength with significant lateral stability demands. Side lunges typically allow less loading than forward or reverse lunges due to reduced mechanical efficiency. Most lifters are limited by hip mobility, adductor strength, and lateral balance. Shallow depth or shortened step width will inflate results. Strict, repeatable execution is required for valid comparisons. Estimated 1RM is calculated from the entered weight used and reps.

Enter total loaded free-end weight

Fix the bar in a landmine base, hold the free end with both hands close to the chest, squat to consistent depth, and stand to full lockout. Do not press, lunge, bounce, lean on the sleeve, shorten depth, or enter per-side load.

Enter one recent Barbell Side Lunge result and one recent Landmine Squat result

First lift: weight used and 1–12 strict reps. Second lift: total loaded free-end weight and 1–12 strict reps. Pounds or kilograms.

Related Tools

• Barbell Side Lunge — View the individual Barbell Side Lunge standards and next strength-level target.
• Landmine Squat — View the individual Landmine Squat standards and next strength-level target.
• Barbell Cossack Squat — Use this related standards tool to examine a closely related exercise without mixing its result into this comparison.
• Barbell Lunge — Use this related standards tool to examine a closely related exercise without mixing its result into this comparison.
• Goblet Squat — Use this related standards tool to examine a closely related exercise without mixing its result into this comparison.
• Barbell Front Squat — Use this related standards tool to examine a closely related exercise without mixing its result into this comparison.