One Arm Dumbbell Row to Pendlay Row (Raw) Conversion Calculator
This One Arm Dumbbell Row to Pendlay Row (Raw) Conversion calculator estimates Pendlay Row (Raw) Conversion strength from One Arm Dumbbell Row performance.
Enter your sex, bodyweight, and One Arm Dumbbell Row performance to see your Pendlay Row (Raw) Conversion estimate, expected range, strength tier, and ratio to bodyweight.
The calculator uses the conversion model for this tool to translate One Arm Dumbbell Row performance into the Pendlay Row (Raw) Conversion estimate. Use the result as a planning estimate, not a guaranteed max or attempt recommendation.
What Your One Arm Dumbbell Row Result Means for Pendlay Row
This calculator turns one strict One Arm Dumbbell Row result into a predicted Pendlay Row 1RM. The result gives you a center estimate, a planning range, and a strength level for the Pendlay Row only.
| Example | One Arm Dumbbell Row result | Estimated One Arm Dumbbell Row max | Predicted Pendlay Row | Expected range | Target level |
|---|---|---|---|---|---|
| 190 lb male | 75 lb one dumbbell rowed by one arm at a time × 8 | 93 lb | 123 lb | 112–130 lb | Novice |
| 150 lb female | 45 lb one dumbbell rowed by one arm at a time × 8 | 56 lb | 81 lb | 71–85 lb | Novice |
For the male example, 75 lb one dumbbell rowed by one arm at a time × 8 predicts 123 lb with a 112–130 lb range. The Novice label rates the predicted Pendlay Row result; it does not rate the One Arm Dumbbell Row result.
How the One Arm Dumbbell Row to Pendlay Row Conversion Works
The calculator keeps the source and target measurement rules separate: the source entry is weight of the one dumbbell rowed by one arm at a time, while the target result is total external weight.
| Step | What the calculator does | Worked example |
|---|---|---|
| 1. Read the source load | Use weight of the one dumbbell rowed by one arm at a time exactly as entered. | 75 lb one dumbbell rowed by one arm at a time × 8 |
| 2. Estimate the source max | Convert the completed set into an estimated source 1RM using the calculator’s approved repetition rule. | 93 lb |
| 3. Map to the target result | Apply the One Arm Dumbbell Row-to-Pendlay Row mapping (0.756 center coefficient for this male example). | 123 lb |
| 4. Show uncertainty | Calculate the lower and upper ends of the expected transfer range. | 112–130 lb |
| 5. Rate the target | Classify the unrounded center against Pendlay Row standards. | Novice |
The conversion matches reviewed strength levels for these two exercises. It does not claim that their loads, repetitions, equipment, or execution are interchangeable—or that the center is guaranteed.
One Arm Dumbbell Row to Pendlay Row Conversion Chart
This chart holds the source set at 5 strict reps. Every value is generated by the same calculation as the calculator.
| One Arm Dumbbell Row result | male estimate | male range | female estimate | female range |
|---|---|---|---|---|
| 40 lb one dumbbell rowed by one arm at a time × 5 | 60 lb | 54–63 lb | 65 lb | 58–69 lb |
| 60 lb one dumbbell rowed by one arm at a time × 5 | 89 lb | 81–95 lb | 97 lb | 86–103 lb |
| 85 lb one dumbbell rowed by one arm at a time × 5 | 127 lb | 115–134 lb | 138 lb | 122–146 lb |
| 120 lb one dumbbell rowed by one arm at a time × 5 | 179 lb | 163–189 lb | 195 lb | 173–206 lb |
| 155 lb one dumbbell rowed by one arm at a time × 5 | 231 lb | 210–244 lb | 252 lb | 223–266 lb |
| 180 lb one dumbbell rowed by one arm at a time × 5 | 268 lb | 244–284 lb | 292 lb | 259–309 lb |
The range reflects transfer uncertainty. Use the center to compare or plan, and use direct Pendlay Row performance to learn your actual result.
Pendlay Row Strength Standards
The calculator rates only the predicted Pendlay Row result. These reference standards use the same bodyweights and sex profiles as the examples above.
| Pendlay Row level | 190 lb male: total external weight | 150 lb female: total external weight |
|---|---|---|
| Beginner | Below 86 lb | Below 52 lb |
| Novice | 86–133 lb | 52–82 lb |
| Intermediate | 134–180 lb | 83–112 lb |
| Advanced | 181–228 lb | 113–142 lb |
| Elite | 229 lb or more | 143 lb or more |
| Stretch benchmark | 257 lb | 165 lb |
The live calculator resolves the target standard for the bodyweight entered. The source exercise keeps its own separate standards.
Key Differences Between One Arm Dumbbell Row and Pendlay Row
These exercises share relevant strength demands, but the differences below are why their raw numbers cannot be interchanged.
| Difference | One Arm Dumbbell Row | Pendlay Row | Why it affects the estimate |
|---|---|---|---|
| Exercise setup and action | one side at a time horizontal pull with one dumbbell | horizontal pull | Source: One side at a time horizontal pull with one dumbbell. Target: Horizontal pull. The difference changes the strength or repetition capacity being measured. |
| Equipment and load convention | dumbbell; Weight of the one dumbbell | bodyweight; Total barbell weight | The exercises record resistance differently, so equal-looking numbers do not represent equal performance. |
| Valid repetition standard | Each rep begins with one dumbbell hanging under control from the working arm, shoulder controlled, body position stable, and the nonworking hand or knee support fixed when support is used. | Set the upper body near parallel to the floor, begin every rep with the bar motionless on the floor, pull it to the lower chest or upper abdomen without hip drive or upper body rise, and return it under control to a complete reset. | Changing either repetition standard changes the exercise being compared and weakens the usefulness of the estimate. |
| Movement and setup | One Arm Dumbbell Row: strict one-arm dumbbell row with the dumbbell pulled toward the lower ribs, hip, or side of the trunk. | Pendlay Row: dead-stop horizontal barbell pull | The starting position and movement path determine the leverage and muscles that can contribute to a valid repetition. |
Getting and Using a Useful One Arm Dumbbell Row-to-Pendlay Row Estimate
Source test: Each rep begins with one dumbbell hanging under control from the working arm, shoulder controlled, body position stable, and the nonworking hand or knee support fixed when support is used. The lifter rows the dumbbell toward the lower ribs, hip, or side of the trunk through a controlled path, then lowers to the same arm-extended start range without heaving, twisting, shoulder collapse, or shortened range.
Target represented: Set the upper body near parallel to the floor, begin every rep with the bar motionless on the floor, pull it to the lower chest or upper abdomen without hip drive or upper body rise, and return it under control to a complete reset.
| Before calculating | What to do |
|---|---|
| Use a valid One Arm Dumbbell Row set | Each rep begins with one dumbbell hanging under control from the working arm, shoulder controlled, body position stable, and the nonworking hand or knee support fixed when support is used. |
| Use 1 to 10 strict repetitions | Enter one whole-number One Arm Dumbbell Row set inside the calculator’s approved repetition range. |
| Keep the measurement convention straight | Enter weight of the one dumbbell rowed by one arm at a time. Read the target as total external weight. |
| Use the range for planning | Start Pendlay Row practice near the conservative end and use the center as the main comparison point. |
| Retest under the same conditions | Keep the One Arm Dumbbell Row setup, range, way of recording resistance, and repetition standard consistent. |
Do not substitute Pendlay Row results entered as One Arm Dumbbell Row results, One Arm Dumbbell Row repetitions performed with a changed setup or range, partial-range, assisted, or momentum-driven One Arm Dumbbell Row repetitions, source resistance recorded under a different convention than weight of the one dumbbell rowed by one arm at a time, multiple sets combined into one repetition total. Those are different tests, so their numbers do not belong in this conversion.
| Result component | How to use it |
|---|---|
| Predicted center | Use it as the main comparison point for the One Arm Dumbbell Row-to-Pendlay Row estimate. |
| Low end of range | Use it as the conservative reference when beginning or resuming Pendlay Row practice. |
| High end of range | Treat it as possible context—not a guaranteed result or attempt recommendation. |
| Pendlay Row strength level | Use it only to understand where the predicted result falls against Pendlay Row standards. |
| Direct Pendlay Row result | Replace the prediction with the actual result once Pendlay Row has been performed under the stated test. |
Example: 75 lb one dumbbell rowed by one arm at a time × 8 predicts 123 lb with a 112–130 lb range. Use 123 lb as the comparison point, treat 112 lb as the conservative edge, and do not interpret 130 lb as a recommended attempt. Once you record a strict Pendlay Row result, use that direct result instead.
Related One Arm Dumbbell Row and Pendlay Row Tools
Use a direct standards tool when you have performed the exercise itself. Use neighboring tools to answer a different question—not to overwrite this conversion.